Author Topic: CRANKCASE LOCATING PINS. REPLACEMENT. (Read 2221 times)

AH1510 · « **on:** October 20, 2009, 03:22:19 PM »

Hello from the sunny left coast. Can the location pins for the crankshaft trust washers and shims be replaced? I found a bent one. Thanks. OLDPAUL.

Bob_Roller · « **Reply #1 on:** October 20, 2009, 04:28:27 PM »

I could be mistaken, but the few pictures I've seen of the locating pins, they appeared to be cast into the engine case .

Justin B. · « **Reply #2 on:** October 20, 2009, 06:19:30 PM »

A bent what, thrust bushing? These are easy for people to mangle up if they forget to block the crank before removing the flywheel...

Rob Valdez 79 R65 · « **Reply #3 on:** October 20, 2009, 06:30:34 PM »

I have a 1980 short block languishing in my garage. Your's for shipping.

AH1510 · « **Reply #4 on:** October 21, 2009, 09:43:16 AM »

Hello Rob,
I will keep you mind about the short block. I will know more when I get the crank out. OLDPAUL.

Rob Valdez 79 R65 · « **Reply #5 on:** October 22, 2009, 06:15:23 PM »

Quote

Hello Rob,
I will keep you mind about the short block. I will know more when I get the crank out. OLDPAUL.

Send me an email, if you are. I check that more often than the forum.

AH1510 · « **Reply #6 on:** October 23, 2009, 10:37:37 AM »

Hell Rob,
Will do. Thanks. OLDPAUL.

News: