The New And Improved Unofficial R65 Forum V2
Technical Discussion => BMW Technical Q&A, Primarily R65 => Topic started by: wilcom on August 07, 2014, 10:55:39 PM
-
After pulling my bike out of mothballs (over a year) I'm back on the road at my new location.
The turn signal switch has died during it's vacation. It appears that I can get a new one for $105 , so I won't be disassembling it in a plastic bag for tedious hours..........but......... the position the switch is in makes it almost useless. I have to go almost underneath the switch to get to it and it's most inconvenient. I can't rotate the lever up any more as it would hit the fairing
Is there any switch gear that is more ergonomically friendly? later model , different model??
-
here is a better shot of the switch..... the turn signal switch is way under there and hard to get to. I might even go for a add on toggle on top any ideas?
-
I know you say it won't turn any further but something may be amiss as that doesn't look like the normal angle for the clutch lever. For maximum comfort and efficiency the lever should point downwards in a line with your arm which brings the turn switch into a better if not perfect position.
-
The bars are too low for him to rotate the controls any further. Slightly taller bars should give the clearance needed to get the controls back into a more user-friendly position.
Classic K bikes have a paddle/button on each side for left/right signals and a separate turn signal cancel (they also have some auto cancelling computer). Could be a lot of work to go to K controls, but maybe you can find somebody on the internet whose retrofitted K controls to an airhead.
-
something may be amiss as that doesn't look like the normal angle for the clutch lever
That's why I love this place! I have had that fairing on there a long time and it has become "normal" to me. You take one look and see where the control is screwed up , good eye Luca.
I can't rotate the control without the lever hitting the fairing, BUT I can move the fairing DOWN (hopefully) and it will allow me to rotate the control back to where it is supposed to be.
Thanks Luca!
-
I'm with Luca in that the bars need a little more rise for good clearance. Add on risers are almost out of the question due to the dash cover. You might find something from Flanders that offers just a touch more clearance and you might even get away without making any cable changes, depending on how much slack you have to work with.
http://www.sideroadcycles.com/ImportedMotorcycles/ImportHandlebars/ImportHandlebarsBMW.html
-
Flanders certainly offers a wide selection of handlebars for BMW motorcycles. I'm currently saving up my aluminum so I can purchase a new pair for my R100S.
Keep in mind the required 22mm diameter of the BMW handlebars. Any bar with a larger o.d. -and there's a lot available- can crack and/or destroy the OEM switch/lever perch assemblies as they are being tightened down.