The New And Improved Unofficial R65 Forum V2
Technical Discussion => BMW Technical Q&A, Primarily R65 => Topic started by: BooG on June 05, 2009, 09:38:22 AM
-
Failed MOT this morning on noisy bearings at front, so pulled em out. One side was OK, other was shot. For anyone who hasn't seen a wasted front wheel bearing race, here is the offender on the left, with the OK one on the right for comparison. Easy to get out, hopefully as easy to re-install tomorrow! I hear there is an issue with getting the right pre-load. Anyone done it? Read Duane's "shakey" method for re-installing..?!
-
Maybe all the vibration from that bad bearing was contributing to your flickering lights! :D
-
Yeah, as well as my teeth falling out, blurring vision and flatulance....!
-
LOL... If that "bad" race has been cleaned and still looks like that then it's for sure FUBAR. Any reason it might have gotten like that? Ride in the rain a lot? Oh, sorry, forgot where you live... :P
-
How did you get the races out? I thought there was some special puller, but I've never done it on my R65. Sorry, nor have I done the shim set up....
-
I'm in the same boat as you, Ed, but I believe heat is supposed to be applied...
-
Maybe all the vibration from that bad bearing was contributing to your flickering lights! :D
Actually,since cleaning a re-lubing my head bearings the light are better(brighter)so the earth contact must have been bad,so your not far from the mark with your comment Justin!!
-
Now, that doesn't surprise me too much...